[. . . ] LNS-W02/T02 LNS-W02K/T02K Series LENS REPLACEMENT AND INSTALLATION PROCEDURE NOTES ON LENS INSTALLATION Lens installation should be performed by the qualified service personnel. Before attempt to install the lens, confirm the model number (both the LCD projector and the lens) and use the proper lens. [. . . ] A D B D Fig-1 LOWER LENS COVER LENS COVER In case figure-2 cabinet. Remove 4 screws of the lens cover and remove the lens cover. Fig-2 2 q IN CASE OF MODEL WITHOUT LENS REMOVE THE COVER PLATE OF THE LENS COVER. (At the step 5 , insert the light-block sheet in the same position as the removed cover plate has been placed. Two screws are not used. ) Use the light-block sheet included with lens. Set the light-block sheet, so that the large rounder side is set over the lens. LIGHT-BLOCK SHEET SCREWS COVER PLATE Fig-3 p Figure shown inside of the cabinet. LENS MOTOR (D) q IN CASE OF MODEL WITH LENS REMOVE THE LENS. Remove screws D (4 screws) which fastens the lens and remove the lens. A (D) (D) (D) C B LENS MOTOR LEAD CONNECTOR " K16B" Fig-4 (D) LENS MOTOR (D) A (D) (D) C B 3 INSTALL THE LENS. (See figure-4, 5) CONNECTOR "K16B" This part wiring should not be tightened. LENS MOTOR LEAD 1. Mount the lens at the lens mounting bracket with screws (4 screws) included with the lens. Connect the lens motor lead to the connector "K16B" of the circuit board. (See figure-4) LENS MOUNTING BRACKET ATTACHED DRIVER Fig-5 4 INSTALL THE LIGHT-BLOCK SHEET. [. . . ] 1. Insert the upper part lens cover and fix them with screws A (4 screws). 2. Insert the lower part lens cover and fix them with screws B (2 screws). B A LOWER LENS COVER Fig-7 fRemoved lens cover in figure-2 is not used, keep the cover for possible reuse when current lens is used. Set the light-block sheet, so that the large rounder side is set over the lens. Insert into the slot. [. . . ]